Skip to content
Fieldstone Water Co.

PFAS

PFAS in Long Island Water

PFAS in water are persistent fluorinated chemicals. Public suppliers on Long Island report PFOA and PFOS in parts per trillion. PFOA and PFOS are 10 ppt each under New York's MCL, and 4.0 ppt each under the federal MCL, with federal compliance due April 26, 2029.

The family

PFAS, PFOA, and PFOS

PFAS is the group name. PFOA (perfluorooctanoic acid) and PFOS (perfluorooctane sulfonic acid) are the two chemicals New York and EPA both set individual drinking-water limits for. Suppliers also report shorter-chain and replacement chemicals. Those have their own pages on this site: PFOA, PFOS, PFBS, PFHxS, PFNA, HFPO-DA (GenX), PFPeA, PFHxA, PFBA, PFHpA, 6:2 FTS, PFPeS.

A result on a community page is the supplier's published figure for that system or distribution area. Homes on private wells are not covered by that report. Nassau County water and Suffolk County water are the two county starting points.

New York

New York's PFAS limit

Table 3 of 10 NYCRR Subpart 5-1 (section 5-1.52) lists perfluorooctanoic acid (PFOA) and perfluorooctanesulfonic acid (PFOS) at 0.0000100 mg/L each. That is 10 ng/L, or 10 ppt, for each chemical. The table PDF (opens in a new tab) is the regulation text.

For those specific organic chemicals, a result over the MCL triggers confirmation sampling. The supplier collects one to three more samples from the same sampling point, as soon as practical but within 30 days. An MCL violation occurs when at least one confirming sample is positive and the average of the initial sample and all confirming samples exceeds the MCL. Table 3 uses a running annual average for trihalomethanes and haloacetic acids. It does not use that method for PFOA or PFOS.

The NYSDOH fact sheet (April 2024) says the state set maximum contaminant levels of 10 ppt each for PFOA and PFOS in 2020, and that public water systems must still meet those state levels until the federal MCLs apply in 2029. Fact sheet (opens in a new tab). A Department of Health question-and-answer sheet dated August 25, 2020, hosted by the New York Rural Water Association, said the MCLs would be effective when the Notice of Adoption was published in the New York State Register on August 26, 2020. August 25, 2020 Q&A (opens in a new tab). The State Register issue itself is not linked here; that host returned an error when this page was checked.

EPA

EPA's PFAS limit

EPA announced the final PFAS National Primary Drinking Water Regulation on April 10, 2024. The Federal Register published it on April 26, 2024. The enforceable MCLs for PFOA and PFOS are 4.0 ppt (4.0 ng/L) each. Public water systems must comply with the MCLs by April 26, 2029, and complete initial monitoring by April 26, 2027. EPA's PFAS drinking-water page (opens in a new tab). Federal Register, April 26, 2024 (opens in a new tab).

The 2024 rule also set MCLs for PFHxS, PFNA, and HFPO-DA, and a hazard index for mixtures of those three plus PFBS. Those four are part of the final 2024 rule until a later final rule changes them. See the proposals below, which are not final.

Proposed only

EPA's May 2026 proposals are not final

On May 18, 2026, EPA announced two proposed rules (extension proposal (opens in a new tab), rescission proposal (opens in a new tab)). The Federal Register published both on May 20, 2026. They are proposed rules, not final rules. Comments closed on July 20, 2026. EPA's own pages still describe both actions as proposals.

The compliance-extension proposal would let a public water system that requests and receives a federal exemption comply with the PFOA and PFOS MCLs by April 26, 2031, instead of April 26, 2029. The proposal does not change the 4.0 ppt MCLs. The extra time would apply only to systems that ask for it and receive it. As proposed, the federal exemption process would apply in states, territories, and Tribes that have not obtained primacy for the PFOA and PFOS MCLs. It would not change New York's 10 ppt MCLs. Federal Register, May 20, 2026, extension proposal (opens in a new tab). EPA's proposal page (opens in a new tab).

A separate proposal would rescind the regulatory determinations and the related MCLs for PFHxS, PFNA, and HFPO-DA (GenX), and the hazard-index limit for mixtures of those three plus PFBS. The proposal says it would not change the PFOA and PFOS MCLs. Federal Register, May 20, 2026, rescission proposal (opens in a new tab). EPA's rescission page (opens in a new tab).

Unless a final rule or a court changes them, the April 2024 MCLs and the April 26, 2029 compliance date are the federal requirements. A challenge to the 2024 rule (AWWA v. EPA, D.C. Cir. No. 24-1188) was argued September 18, 2026 and is pending. New York's enforceable MCLs remain 10 ppt each for PFOA and PFOS.

From the reports on this site

Highest reported PFOA and PFOS levels

Each row is a supplier result already published on a community page, with its limit, source, and date. “Level” is the figure stored for that page: the report’s average when it prints one, otherwise the published level. When the report prints a range, that range is shown too. The violation column is copied from the report (Yes or No). It can read “No” even when a single sample is over the MCL, because New York uses confirmation sampling rather than one result. A raw-water result is from a well before treatment or blending, not water in the distribution system. Leaving out raw-water and pre-treatment samples, these rows are distribution-system levels. Communities on the same distribution area share one result, so the row names one community and the supplier or area. When the cited report does not name that community, the row leads with the supplier and says where the mapping comes from. A dagger means the area was inferred from neighboring communities. These are not new measurements and not a test of one house. Full tables: PFOA and PFOS.

PFOA

Highest PFOA results in the supplier reports compiled on this site, with limit, source, and date.
CommunityLevelLimitSupplier / areaSource and date
Glen CoveNassau10.1 ng/LRange ND–10.1Report violation column: YesThe City of Glen Cove's 2025 report marks PFOA 'Yes' in its violation column. The report does not describe the violation in its text. Contact the City of Glen Cove Water Department for details.10.0NYS MCLCity of Glen Cove Water DepartmentCity of Glen Cove Water Department 2025 Annual Water Quality Report (opens in a new tab)2025 report · verified 2026-11-11
Oyster Bay Water DistrictCentre IslandNassauThe cited report does not name Centre Island. EPA's UCMR 5 occurrence data (opens in a new tab) lists the system for the community's ZIP codes. That mapping is not in the report.9.81 ng/LRange ND–9.81Report violation column: No10NYS MCLOyster Bay Water DistrictOyster Bay Water District 2025 Annual Water Quality Report (opens in a new tab)2025 report · verified 2026-11-11
Greenlawn Water DistrictElwoodSuffolkThe cited report does not name Elwood. The service-area boundary the NYS Department of Health supplies to EPA places most of Elwood in this district. EPA public water system service areas (opens in a new tab). That mapping is not in the report.8.88 ng/LRange ND–8.88Report violation column: No10NYS MCLGreenlawn Water DistrictGreenlawn Water District 2025 Annual Water Quality Report (opens in a new tab)2025 report · verified 2026-11-11
Westbury Water DistrictNew CasselNassauThe cited report does not name New Cassel. The service-area boundary the NYS Department of Health supplies to EPA places most of New Cassel in this district. EPA public water system service areas (opens in a new tab). That mapping is not in the report.8.7 ng/LRange ND–8.7Report violation column: No10.0NYS MCLWestbury Water DistrictWestbury Water District 2025 Annual Water Quality Report (opens in a new tab)2025 report · verified 2026-11-11
Baxter EstatesNassau8.03 ng/LRange ND–8.03Report violation column: No10NYS MCLPort Washington Water DistrictPort Washington Water District 2025 Annual Water Quality Report (opens in a new tab)2025 report · verified 2026-11-11

PFOS

Highest PFOS results in the supplier reports compiled on this site, with limit, source, and date.
CommunityLevelLimitSupplier / areaSource and date
Greenlawn Water DistrictElwoodSuffolkThe cited report does not name Elwood. The service-area boundary the NYS Department of Health supplies to EPA places most of Elwood in this district. EPA public water system service areas (opens in a new tab). That mapping is not in the report.7.07 ng/LRange ND–7.07Report violation column: No10NYS MCLGreenlawn Water DistrictGreenlawn Water District 2025 Annual Water Quality Report (opens in a new tab)2025 report · verified 2026-11-11
Garden City ParkNassau5.83 ng/LRange ND–5.83Report violation column: No10NYS MCLGarden City Park Water DistrictGarden City Park Water District 2025 Annual Water Quality Report (opens in a new tab)2025 report · verified 2026-11-11
East WillistonNassau5.29 ng/LRange 4.13–5.29Report violation column: No10NYS MCLIncorporated Village of Williston Park Water DepartmentIncorporated Village of Williston Park Water Department 2024 Annual Water Quality Report (opens in a new tab)2024 report · verified 2026-11-11
MineolaNassau5.15 ng/LRange ND–5.15Report violation column: No10NYS MCLIncorporated Village of Mineola Water DepartmentIncorporated Village of Mineola Water Department 2025 Annual Water Quality Report (opens in a new tab)2025 report · verified 2026-11-11
Glen CoveNassau4.86 ng/LRange ND–4.86Report violation column: No10.0NYS MCLCity of Glen Cove Water DepartmentCity of Glen Cove Water Department 2025 Annual Water Quality Report (opens in a new tab)2025 report · verified 2026-11-11

Treatment

What a PFAS water filter can and cannot do

A PFAS water filter is a product question. It is separate from whether a utility's published result is under a limit. EPA's page on filters certified to reduce PFAS (opens in a new tab) is about point-of-use filters, a water treatment system used at a single faucet or other fixture. It describes granular activated carbon, which traps chemicals as water passes through it, ion exchange resin, and reverse osmosis. EPA says: "It's important to note that the current certification standards for PFAS filters (as of April 2024) do not yet indicate that a filter will remove PFAS down to the levels EPA has now set for a drinking water standard." (EPA, filters certified to reduce PFAS (opens in a new tab)). The 2024 federal rule lists granular activated carbon, anion exchange, reverse osmosis, and nanofiltration as best available technologies for public water systems. Federal Register, April 26, 2024 (opens in a new tab).

EPA says: "Look on product labels for certification under NSF/ANSI 53 or NSF/ANSI 58 for PFAS reduction." (EPA, filters certified to reduce PFAS (opens in a new tab)). Confirm the model in a certifier's directory (NSF, IAPMO, WQA, and the others EPA names). A listing covers the reductions it names. It does not mean every PFAS is reduced, and this page does not claim any filter removes all of them.

Whole-house carbon filtration is a separate point-of-entry option. This page does not name a brand or a certified reduction for it. Carbon is not an effective treatment for 1,4-dioxane. The NYSDOH Q&A dated August 25, 2020, citing 10 NYCRR Subpart 5-1.91(d), names advanced oxidation (AOP) as the best available technology for it. Q&A (opens in a new tab). Whole-home filtration.

Under-sink reverse osmosis treats the drinking-water tap, not every shower. Call a specific model certified or listed only when a directory shows that model. This page does not name a brand or a certified reduction for it. Under-sink reverse osmosis.

Shorter-chain PFAS are a different job from PFOA and PFOS. The PFBS page explains why carbon holds them less readily. None of this changes the number in a supplier's annual report. A home system, if it is maintained on the schedule the manufacturer states, treats water after it reaches the house.

Testing

A free in-home screen is not a PFAS lab test

Fieldstone's free in-home water screen measures chlorine, hardness, iron, nitrate, and pH. It is not a certified laboratory test for PFAS or for 1,4-dioxane. PFAS testing needs a laboratory accredited by the New York State Department of Health Environmental Laboratory Approval Program (ELAP) for a drinking-water PFAS method. NYSDOH's lab list for its Private Well PFAS Testing and Mitigation Rebate Pilot Program names laboratories accredited in EPA Method 537.1, Version 2 or EPA Method 533. ELAP (opens in a new tab). Accredited laboratories (opens in a new tab). NYSDOH on PFAS and private wells (opens in a new tab).

Book the screen on the free in-home water test page. If the supplier report or a private well makes PFAS the question, the next step is an ELAP-accredited lab, not the in-home screen.

Common questions

PFAS, answered

Sources

Primary sources for the limits

A plain-text copy of this page is at /water/contaminants/pfas.md.

Start here

Want a screen of your tap, or a lab test for PFAS?

Fieldstone's free in-home screen is chlorine, hardness, iron, nitrate, and pH. It is not a certified laboratory test for PFAS. If PFAS is the question, the next step is a NYSDOH ELAP-accredited lab.