Skip to content
Fieldstone Water Co.

Nassau County · Public water (Plainview Water District)

Water Quality in Old Bethpage, NY — What’s In Your Water

Old Bethpage's water is supplied by Plainview Water District. The most recent published results show Combined Radium 226/228 at 5.45 pCi/L (above the limit), Copper at 0.20 mg/L. Every figure below is shown against its NY or EPA limit and cited to its source.

Reported contaminants

Old Bethpage water, by the numbers

Data from Plainview Water District 2025 Water Quality Report · Verified 2026-11-11

ND means not detected. Units: µg/L is micrograms per liter (parts per billion); ng/L is nanograms per liter (parts per trillion); mg/L is milligrams per liter (parts per million). Status uses the words below, near, exceeds, or trace — not color alone.

Source: Plainview Water District 2025 Annual Water Quality Report (opens in a new tab)

Contaminants reported in Old Bethpage, Nassau County drinking water, with detected level, regulatory limit, and status.
SubstanceDetected levelLimitStatus
PFAS
PFOA (about this substance)3.27 ng/LRange ND–3.2710NYS MCLBelow limit
PFBA (about this substance)18.6 ng/LRange ND–18.6No regulatory limit—
PFHxA (about this substance)2.02 ng/LRange ND–2.02No regulatory limit—
PFPeA (about this substance)2.06 ng/LRange ND–2.06No regulatory limit—
Industrial solvents & 1,4-dioxane
1,4-Dioxane (about this substance)0.61 µg/LRange ND–0.611.0NYS MCLBelow limit
1,1,1-Trichloroethane (about this substance)1.8 µg/LRange ND–1.85EPA MCLBelow limit
Nitrate, metals & inorganics
Combined Radium 226/228 (about this substance)5.45 pCi/LRange 3.03–5.45Highest single result 5.45 pCi/L. The report's violation column is No.5EPA MCLNo violation reported
Nitrate-Nitrite (as N) (about this substance)8.5 mg/LRange 0.68–8.510EPA MCLNear limit
Nitrate (about this substance)8.4 mg/LRange 0.66–8.410EPA MCLNear limit
Turbidity (about this substance)3.8 NTURange ND–3.85EPA MCLBelow limit
1,1-Dichloroethane (about this substance)3.6 µg/LRange ND–3.65EPA MCLBelow limit
Odor (about this substance)2.0 UnitsRange ND–2.03NYS secondary standardBelow limit
Color (about this substance)8.0 UnitsRange ND–8.015NYS secondary standardBelow limit
Perchlorate (about this substance)5.8 µg/LRange ND–5.818NYS MCLBelow limit
Thallium (about this substance)0.45 µg/LRange ND–0.452EPA MCLBelow limit
Gross alpha (about this substance)3.23 pCi/LRange ND–3.2315EPA MCLBelow limit
Chloride (about this substance)40.5 mg/LRange 11.9–40.5250NYS secondary standardBelow limit
Formaldehyde (about this substance)5.5 µg/LRange ND–5.550EPA MCLBelow limit
Nitrite (about this substance)0.1 mg/LRange ND–0.11EPA MCLBelow limit
Gross beta (about this substance)4.76 pCi/L (6)Range 0.11–4.7650EPA MCLBelow limit
Uranium (about this substance)1.62 µg/LRange ND–1.6230EPA MCLBelow limit
Sulfate (about this substance)11.4 mg/LRange ND–11.4250NYS secondary standardBelow limit
Barium (about this substance)0.059 mg/LRange 0.004–0.0592EPA MCLBelow limit
Copper (about this substance)0.016 mg/LRange ND–0.0161.3EPA action levelBelow limit
Zinc (about this substance)0.025 mg/LRange ND–0.0255NYS secondary standardBelow limit
Iron (about this substance)0.23 mg/LRange ND–0.23300NYS secondary standardBelow limit
Manganese (about this substance)0.094 mg/LRange ND–0.094300NYS secondary standardBelow limit
Calcium (about this substance)66.8 mg/LRange 2.2–66.8No regulatory limit—
Magnesium (about this substance)3.1 mg/LRange 1.2–3.1No regulatory limit—
Nickel (about this substance)0.014 mg/LRange 0.0013–0.014No regulatory limit—
Sodium (about this substance)13.9 mg/LRange 6.5–13.9No regulatory limit—
Ammonia (as N) (about this substance)2.9 mg/LRange ND–2.9No regulatory limit—
Alkalinity (about this substance)123.0 mg/LRange ND–123.0No regulatory limit—
Total Dissolved Solids (about this substance)274.0 mg/LRange 27.0–274.0No regulatory limit—
Lead & copper
Lead (about this substance)ND µg/L(90th percentile)Range ND–2.515EPA action levelTrace — detected in some samples
Copper (about this substance)0.20 mg/L(90th percentile)Range ND–0.41.3EPA action levelBelow limit
Disinfection byproducts
Total Trihalomethanes (about this substance)1.3 µg/LRange ND–1.380EPA MCLBelow limit
Chlorate (about this substance)18.5 µg/LRange ND–18.5No regulatory limit—

Water characteristics

Water characteristics reported in Old Bethpage, Nassau County drinking water.
SubstanceDetected levelLimitStatus
Free Chlorine (about this substance)1.03 mg/LRange 0.57–1.034.0EPA MRDLBelow limit
pH (about this substance)8.3 UnitsRange 4.4–8.3No regulatory limit—
Hardness (total) (about this substance)180.0 mg/LRange 10.3–180.0No regulatory limit—
Calcium hardness (about this substance)167.0 mg/LRange 5.6–167.0No regulatory limit—

Status reflects the average of all samples. Individual readings may be higher; see range.

Where the report prints both an average and a range, the status column here is judged on the average; where it prints a maximum or a 90th-percentile result, that figure is used. The report carries 1 notice: No violations reported: 'We are pleased to report that our drinking water meets all Federal and State requirements.' (page 2). All table rows print Violation 'No'. Footnote (9): initial point-of-entry 1,4-dioxane result of 1.4 ug/L at Well No. 1-2 averaged down to 0.7 ug/L following a resample of ND. Footnote (2): initial color result of 22 units at Well No. 5-2 averaged down to 11 units following a resample of ND. 100% of Old Bethpage's land lies inside a public water service area (Plainview Water District and others), per the NYS Department of Health boundaries EPA publishes. A service area is where mains run; a home inside it can still be on a private well.

Your water district

Who supplies Old Bethpage’s water

What the numbers mean

Like most of Nassau, Old Bethpage runs on treated public water. The day-to-day concerns here are the chlorine and chloramine used to keep the supply safe through the distribution system, plus the naturally high hardness of Long Island groundwater — the mineral content that leaves scale on fixtures and spots on glassware. Neither is an emergency, but both are exactly what point-of-entry carbon filtration and softening are designed to address.

What this means for filtration

Matching Old Bethpage’s water to a system

For Old Bethpage, the numbers point first to under-sink reverse osmosis, whole-house carbon filtration, and whole-house + softener combo: dissolved contaminants close to their limits.

  • Recommended

    Under-Sink Reverse Osmosis

    Dissolved contaminants close to their limits

    Nitrate averaged 8.4 mg/L with samples up to 8.4 against a 10 mg/L limit — the closest number to its limit here. It passes straight through carbon; reverse osmosis is designed to reduce it at the tap. PFOA/PFOS reached 3.27 ng/L (ppt) in at least one sample — under New York's 10 ppt limit. Whether an under-sink reverse osmosis model reduces PFOA or PFOS depends on that model's certification or performance data sheet. Perchlorate was detected up to 5.8 µg/L (limit 18).

    Explore Under-Sink Reverse Osmosis
  • Recommended

    Whole-House Carbon Filtration

    Solvent traces and chlorine in the supply

    Free chlorine averaged 1.03 mg/L at the entry point (limit 4), the residual that gives tap water its pool taste and dries skin and hair. Solvent traces were detected: 1,1,1-Trichloroethane up to 1.8 µg/L (limit 5 each). Whether a whole-house carbon model reduces those solvents is on that model's data sheet.

    Explore Whole-House Carbon Filtration
  • Recommended

    Whole-House + Softener Combo

    Hardness 180 mg/L, about 10.5 grains per gallon

    At 180 mg/L (10.5 gpg) this is hard water: it scales water heaters, spots glassware and leaves film on skin. A softener paired with carbon is the standard fix above 7 grains.

    Explore Whole-House + Softener Combo

Questions

Old Bethpage water FAQ

Free in-home test

See what’s really in your Old Bethpage water.

Published reports cover the public supply — a free in-home test measures your taps (and your well, if you have one), then we walk you through the results.